This kit include

• i-Stamp board
• AX-2SX activity board
• CX-232 serial port cable
• SLCD16x2 Serial LCD module
• Uni-polar stepper motor
• Documentation
• CD-ROM

i-Stamp microcontroller board

• Function capabilities are compatible with BASIC Stamp 2SX module (BS2SX-IC)
• 50 MHz clock frequency. Operate up to 10,000 P-BASIC command/second
• 16KByte memory, separate 8 sections, 2KByte/each, erasable 100,000+ times
• 32 byte RAM with 64 byte Scratchpad RAM
• Consumption 65mA in full operation and 200mA in sleep mode
• Connecting to PC’s serial port for programming and debugging
• 16 I/O, freedom seperated work or set in groups from 4, 8 and 16 pins
• 30mA/30mA source/sink current. Maximum 60mA/60mA source/sink current per 8-pins groups (P0-P7/P8-P15)
• I/O pin can drive LED (with current limit resistor) and 6V servo motor directly
• LED power status
• Board sizes 1.7" x 1.2"
• Develop with BASIC Stamp Editor program

AX-2SX Activty board

• Support i-Stamp
• In -system programming and Debugging via serial port
• 8-LED display
• Relay driver with relay 12V
• Uni-polar Stepper motor driver share with LED on P0-P3 of i-Stamp
• Voice-coil 8W speaker
• LDR light sensor with RC circuit
• 4-Push button switch with resistor pull-up
• Serial interface connector (P15)
• Use with DC adapter 12V 500mA (not included)
• Polarity protection circuit